Make a donation

Author Topic: Cruise control retro fit?  (Read 2220 times)

Offline dan930

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 0
  • -Receive: 56
  • Posts: 1450
Re: Cruise control retro fit?
« Reply #15 on: August 30, 2013, 09:04:27 am »
Can anyone confirm that if my car is 07 plate and I have the diagnostic wire going into the control module then I only require the stalk and coding on vag com to make it work? 1KO 953 513 with no additional cable

Eddie-NL is the cruise control  man , He will know exactly what you need  and is always helpful

+2....he did two of my golfs

He can do it blindfolded,no joke


MK6 golfR dsg
AKS TUNED
NORTECH PERFORMANCE HTA3071
R TECH custom map

Offline DAZ1985

  • Always Involved
  • ****
  • Thank You
  • -Given: 9
  • -Receive: 1
  • Posts: 75
Re: Cruise control retro fit?
« Reply #16 on: August 30, 2013, 09:22:36 pm »
Managed to do it today. Not too bad of a job once you find the hidden clips on the module.

I didn't need the wire either which saved abit of time

Had a scare moment when the steering position sensor showed a fault but after reset it, all was good

1K0 593 513 G
Tornado ED30 #673 stage1 map, miltek cat back, Sachs clutch, panel filter, WALK, eibach pro kit, s3 brakes all round
309bhp @fly

Offline DAZ1985

  • Always Involved
  • ****
  • Thank You
  • -Given: 9
  • -Receive: 1
  • Posts: 75
Re: Cruise control retro fit?
« Reply #17 on: August 30, 2013, 09:23:32 pm »
 :drinking: for the replies again though
Tornado ED30 #673 stage1 map, miltek cat back, Sachs clutch, panel filter, WALK, eibach pro kit, s3 brakes all round
309bhp @fly