Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Front pad warning sensor  (Read 929 times)

Offline DanED30GTI

  • Always Involved
  • ****
  • Thank You
  • -Given: 3
  • -Receive: 3
  • Posts: 64
    • Email
Front pad warning sensor
« on: September 15, 2013, 01:26:48 pm »
Afternoon lads,

Just ordered some new discs and pads for the front as they desperately need doing. Only question is when I replace these will the pad warning sensor reset itself automatically or will I need to get someone to reset it via vcds?

Thanks
Logged

Offline Scottymon

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 83
  • -Receive: 125
  • Posts: 2139
  • UnNaturally Aspirated
  • My Ride: http://www.voodish.co.uk/misc/6n/6n-alive1.jpg
Re: Front pad warning sensor
« Reply #1 on: September 15, 2013, 02:20:13 pm »
Crickey they must have been low to get the warning to come on... never had that myself.  I'm 99% sure it will reset automatically, but if not, drive it for a bit and see if it goes out... if that fails then pull the neg off the battery and retry.  IF that fails, cut the bloody thing off and twist the wires together. :party:
Logged

Offline DanED30GTI

  • Always Involved
  • ****
  • Thank You
  • -Given: 3
  • -Receive: 3
  • Posts: 64
    • Email
Re: Front pad warning sensor
« Reply #2 on: September 15, 2013, 04:38:53 pm »
Cheers mate. Good advice. Ill give those a try just hope it doesn't come to the chopping wires part! Haha
Logged
Pages: [1]   Go Up
« previous next »