All Things Mk5 > Performance Modifications

ko4 on a ko3 car questions ?

(1/5) > >>

gillm:
hi guys will my milltek down pipe fit a ko4 ?
will my neuspeed p-flow fit it ?
will/can revo change the software for this ?
and will the forge dv im using on my ko3 work on the ko4 ?


thanks guys

Janner_Sy:
as far as im aware everything is a straight swap DP and Intake wise.

not sure about the DV as it will have to be relocated to the front of the engine, and revo, superchips etc all do a stge 3 conversion for k04 upgrades

bacillus:
hi guys will my milltek down pipe fit a ko4 ? Yes
will my neuspeed p-flow fit it ? Not sure
will/can revo change the software for this ? Yes
and will the forge dv im using on my ko3 work on the ko4 ? No

Hurdy:
Your downpipe is a slightly smaller diameter than the one Milltek developed for the K04, but I understand that the flange can be made to fit.

The Neuspeed P-flow would need a take off pipe for the remote location of the Diverter valve. If it doesn't have one it will need one tapping into it.

Revo should be able to do software for this, but it would not be as simple as a stage 2+ remap. This is partly due to the different compression ratio of the pistons - which are lower on the ED30. The best bet is to give Revo a ring as I'm sure they have done this before at some point. It maybe that the map will be a stage 3 remap which is more custom than the 2+ map.

The Forge K03 diverter valve is bolted directly onto the turbo, wheras the K04 Forge DV is located manually at the front of the engine bay. It would work, but not as well as the specific one and would also need adapting to fit.

gazbutS3:
Pretty sure Revo do have a map for K04 conversion :happy2:

Navigation

[0] Message Index

[#] Next page