yellow wire on kufatec looms for xenons

[rich83]

No, the yellow wire should already have the pins on them? 

my looms are used so terminal has been cut off 

also finding it difficult to get the connector in the headlight.... GRRRRR

Mine didnt have  terminal on either, just a short 6" wire with a bare end. Ive had my xenons in 2 mk5s now over the last 4/5 years and never wired that wire in.... CBA! 

[D8MOA]

No, the yellow wire should already have the pins on them? 

my looms are used so terminal has been cut off 

also finding it difficult to get the connector in the headlight.... GRRRRR

Mine didnt have  terminal on either, just a short 6" wire with a bare end. Ive had my xenons in 2 mk5s now over the last 4/5 years and never wired that wire in.... CBA! 

think i will be doing the same haha

i still think i have the wrong Kufatec looms as connector wont fit!

[rich83]

Pictures?

[D8MOA]

Pictures?

i will do some pics tomorrow...watch this space 

[D8MOA]

http://imageshack.com/a/img36/6494/f8vq.jpg

looks like the purple part in the light is causing the issue

[rich83]

Looks ok... does it not fit?

[STV4R]

Sorry to hi jack your thread, but which adapters did you order? Because mine didn't come with the yellow loom to activate the shutters. Just a gray bit that's a few inches long.

[D8MOA]

Looks ok... does it not fit?

Nope it no fit

[George10]

I bought my adapters off eBay, run them through my underside of the dash then connected them to the cecm which is under the steering wheel. Pretty simple job, but you obviously need vcds if you want bi-xenon