All Things Mk5 > R-Tech Zone

Stage 2 Hardware Requirements

(1/3) > >>

Redemption:
I can't find the post that I'd originally seen that listed the parts required for a Stage 2 Remap on an ED30/Pirelli DSG. Could you let me know what's required please?

As I understand it. R-Tech Stages differ with regards to hardware compared to other tuners.

Ta! :happy2:

Redemption:
Answering my own question it seems I need a TBE, Upgraded Intercooler and Induction Kit.

DanED30GTI:
For stage 2 I would go TBE and induction kit. These will work hand in hand and Niki will get some good gains at this stage if using decent hardware.

I would only really add inter cooler at stage 2+ as it's more for safety really with the addition of an upgraded hpfp

R-tech-Nick:
Hello,  we do custom mapping unique to each hardware setup so we don't state must have hardware at each stage.  All we say to customer is work out a budget and power range you want then plan from there.   The power comes from getting the hardware flowing it's best, the more research and reading you do the more you will gain and "could" end up saving money as the expensive brand name bolts are not always the best for flow/power.

Stage 2 u can get away with just induction kit and downpipe Decat.   To get the higher numbers and more area under the curve at stage 2 you would want to go full exhaust, decent induction kit, fmic ect and also budget for a clutch.

Ball is on your court in regards to hardware, but remember with mapping the hardware is always the limiting factor.

Nick

Redemption:
Thanks Nick!

At the mo I'm looking at a BCS TBE Powervalve with Motorsport Cat. Induction Kits is where I'm a bit stuck as I'd prefer something relatively quiet. Car will have DSG so no need for clutch etc.

Not after chasing big BHP figures as I want useable power and with a linear throttle map.

Jase

Navigation

[0] Message Index

[#] Next page