All Things Mk5 > How to Guides / Troubleshooting
Emptied my Catch Can Today……..
RedRobin:
--- Quote from: CocoPops on October 22, 2009, 08:41:14 am ---
--- Quote from: RedRobin on October 20, 2009, 10:07:57 pm ---^^^^
Gotcha! Cheers! :drinking:
No wonder - I've been running with it fully open. Very illogical design for doing things imo.
--- End quote ---
Actually..It's very logical...
if it is tightened against the can.... it will rattle undone and sit at the lowest point of it's thread.
If, however, it is "undone" fully to the bottom of it's thread... it's go nowhere to rattle undone to.
Make sense?
--- End quote ---
....Yes, the 'rattle-undone' precaution does make very good sense. It's only that our my brain is so hardwired into closure being both clockwise and against a surface. Also 'loose' equals 'open' in my brain and it doesn't tighten until the very bottom (tight arse?). There's nothing to inform the consumer about this in the instructions pdf.
I'm sorry but I'm not a 'hater' of this product but just critical of how BSH haven't bothered to think it through enough imo. The tank itself is very utility in its design appearance but the whole kit is very competitively priced.
[I'm possibly changing mine today and will post a new thread]
:drinking:
edition_30:
Sorry to go off topic guys but im fitting mine this weekend & am still confused of the way the hoses should go...
should it be right hand nipple on the block to side port of can?
KRL:
--- Quote from: edition_30 on October 22, 2009, 02:07:31 pm ---Sorry to go off topic guys but im fitting mine this weekend & am still confused of the way the hoses should go...
should it be right hand nipple on the block to side port of can?
--- End quote ---
Yes that is right. BSH say it works best this way :happy2:
edition_30:
Cheers fella :happy2:
Navigation
[0] Message Index
[*] Previous page
Go to full version