Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Help Needed...  (Read 973 times)

Offline AndrewWillis

  • Always Involved
  • ****
  • Thank You
  • -Given: 3
  • -Receive: 5
  • Posts: 81
    • Email
Help Needed...
« on: October 11, 2014, 05:15:19 pm »
I started to fit my boot mounted DAB aerial today and ran into a problem. I have taken as much trim off as I can, but I do not have a long reach Torx bit, to undo the B Pillar trim.  I was wondering if anybody near Northampton was available tomorrow with one of these? I will pay and supply tea/coffee.

Many thanks
Andrew
Logged
05, 3door Red GTI DSG, BCS Powervalve 200 Cell, DNX525DAB, Xenons, R-Tech 2+

Offline dazza

  • Admin
  • Just look at my post count
  • *
  • Thank You
  • -Given: 90
  • -Receive: 190
  • Posts: 2133
  • Coding Boffin
    • Email
  • My Ride: https://www.mk5golfgti.co.uk/forum/index.php?PHPSESSID=bcvbd7ndde96hcrc0rfq71nllo&/topic,90967.msg917089.html#msg917089
Re: Help Needed...
« Reply #1 on: October 11, 2014, 05:29:30 pm »
I have a little set like this seems to have every thing i need. Either used with small wrench or screwdriver.

http://www.ebay.co.uk/itm/100-PC-Chrome-Vanadium-Security-Screwdriver-Tamperproof-Torx-Hex-Bit-Set-Case-/360984768283
Logged
05 | Tornado Red | DSG

Offline AndrewWillis

  • Always Involved
  • ****
  • Thank You
  • -Given: 3
  • -Receive: 5
  • Posts: 81
    • Email
Re: Help Needed...
« Reply #2 on: October 11, 2014, 05:33:39 pm »
The trouble I'm having is the torx bit I have connected to a screwdriver won't fit into the gap.  It needs to be like these

http://images.maplinmedia.co.uk/eklind-torx-key-long-arm-set-of-7-t10-t40.jpg?w=283&h=283&r=4&o=C3Z25lZyWqrmxkLuUpnxTx0e7@0j&V=XHW@

 
Logged
05, 3door Red GTI DSG, BCS Powervalve 200 Cell, DNX525DAB, Xenons, R-Tech 2+

Offline lukemk5gti

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 28
  • -Receive: 118
  • Posts: 1845
    • Email
  • My Ride: http://www.mk5golfgti.co.uk/forum/index.php/topic,89715.msg907250.html#msg907250
Re: Help Needed...
« Reply #3 on: October 11, 2014, 06:15:36 pm »
Get creative is say!!  Tape your torx to an Allen key? Usually those internal torx screws are kept quite loose.

I removed my pillar trim with fingertip strength
Logged
Pages: [1]   Go Up
« previous next »