Polar FIS+ had to remove unit to get car to start??

[bacillus]

Cheers for the heads up! ive been on their site and registered on the forum and had a look at the installation guide - doesn't look hard, just the positioning looks awkward as you say - cheers guys

What MY car do you have as the gateway position changed in post 2007 cars.

[GTi-Andy]

What MY car do you have as the gateway position changed in post 2007 cars.

Ive an early 2007 GTi, but don't know what MY that is, sorry

[Shoduchi]

Probably it's at least MY07. Mine is MY09 and it's from late 2008.

[Viking]

What MY car do you have as the gateway position changed in post 2007 cars.

Ive an early 2007 GTi, but don't know what MY that is, sorry

Hey mate. When you get your new Bluetooth Fiscon kit fitted, you'll have an extra menu with more functions than standard anyway.

[heavyd]

sorry for the thread hi-jack guys, but how easy/difficult are these to install? any instructions on PDF anywhere - Im really tempted in getting one - ta

All I had to do is disconnect the battery, pull out the cubby  hole below the light switch, unclip the relay holder, reach behind and pull the Can gateway out, unplug it, job done,.

Car started straight away tonight, looks like the cable ties did their job hopefully.
Out of curiousity, how low do peoples battery voltage go to when the enginbe isn't running?

Thanks for all the advice so far folks

[fab5freddy]

12V normally on mine, runs at 14V when engines going 

[Shoduchi]

12V normally on mine, runs at 14V when engines going 

Old battery 11,9V-12V and 12,4V with new battery. 14V or near when engine's running (depends how much stuff you have turned on).

[heavyd]

Thanks for info, wasn't sure as mine goes down to about 11.7v after its been sitting, but straight to 14.4v when engine is running