UPDATEJust fitted cruise control today plus the wire. It was pretty straight forward, was just a pain getting the wipers back in the original position after removing it to install the wire.
Had the Kufatec Heated Seats loom arrive too, spent all day yesterday fitting it in, As my seats were out of a 2007 i had to switch the looms around, which isnt too bad. All wired up but i damaged the wire that goes to the CECM so doesnt work at the moment. Getting a repair wire this week and will try again next weekend. Getting colder now and its harder to work on the car outside. Just to add, the wire loom wasnt colour coded, all the wires were grey, but its not hard to identify what is what.
2 Earth ring terminals
1 thick wire with big connector for live
1 thin wire with small connector for ignition
1 thin wire which says "pin 1" on it for the CECM,
4 wires going to the heater pane area (2 single cables and then 2 cables going into 1 connector)
Thanks to
@Eddie-NL for his assistance on the wires.
Also some better shots of the car since cleaning it