Make a donation

Author Topic: Rear caliper piston sticking  (Read 1304 times)

Offline Stamanatic

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 3
  • Posts: 147
    • Email
Rear caliper piston sticking
« on: November 09, 2014, 04:27:33 pm »
Hello,

Had an issue with my rear caliper kind of sticking, I could kind of move the wheel by hand but it didn't rotate freely, had a look at the handbrake cable that was only replaced last year and is fully retracting so that's not the issue.

Then I reset the piston, wheel spun fine then, then I went a for drive to test the brakes then jacked it up again and it was back to where it was sticky, difficult to rotate by hand, so I guess the piston isn't really retracting itself.

Any ideas? Cheers

Offline daddykool

  • Taking part
  • ***
  • Thank You
  • -Given: 0
  • -Receive: 0
  • Posts: 35
    • Email
Re: Rear caliper piston sticking
« Reply #1 on: November 09, 2014, 06:36:32 pm »
I had the same problem this week, had to have new caliper fitted!

Offline AndyBrown

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 23
  • -Receive: 17
  • Posts: 512
    • Email
Re: Rear caliper piston sticking
« Reply #2 on: November 09, 2014, 06:37:08 pm »
I had the same problem, failed mot because of it, needed a new caliper unfortunately

Offline Stamanatic

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 3
  • Posts: 147
    • Email
Re: Rear caliper piston sticking
« Reply #3 on: November 10, 2014, 02:11:58 pm »
Same side? Checked the seal and it was all good and clean, pity don't see how much could go wrong with such simple engineering.