Author Topic: Black ED30 5-door aka The Brighton Bullet! (Read 10453 times)

Georrge · « **Reply #15 on:** January 06, 2015, 09:41:16 pm »

Looks amazing!

Are they genuine exonons or are they the depo lookalikes?
I'm getting tempted to buy a pair of depo lookalikes as my current headlights aren't in the best condition and it's really starting to bug me

ryangerry · « **Reply #16 on:** January 07, 2015, 06:16:03 pm »

As in the headlights? There genuine ones

adminkatana · « **Reply #17 on:** January 08, 2015, 06:06:38 pm »

Quote from: ryangerry on January 05, 2015, 07:12:45 pm

*

*

I took a similar shot yesterday! Your car has a non Ed30 twin

ryangerry · « **Reply #18 on:** January 09, 2015, 05:17:15 pm »

Looking good bud just got my rear gloss badge today so that will be going on tomorrow

adminkatana · « **Reply #19 on:** January 09, 2015, 06:17:17 pm »

Quote from: ryangerry on January 09, 2015, 05:17:15 pm

Looking good bud just got my rear gloss badge today so that will be going on tomorrow

Thanks, any photos would be great, I'm considering switching to black badges :-)

ryangerry · « **Reply #20 on:** January 10, 2015, 03:54:58 pm »

Badge arrived today another simple 5 minute mod. All that's left now is the some 12mm spacers front and rear and the paper work to come back for my private reg
G3RHY

Georrge · « **Reply #21 on:** January 10, 2015, 08:22:17 pm »

Where did you get the badge from? I got a badge that was supposedly meant to stick on top of the original silver, and fit perfectly.. it didn't

samx300 · « **Reply #22 on:** January 10, 2015, 08:43:02 pm »

Quote from: Georrge on January 10, 2015, 08:22:17 pm

Where did you get the badge from? I got a badge that was supposedly meant to stick on top of the original silver, and fit perfectly.. it didn't

^^ +1 on this. I had the same issue with my boot badge. The replacement that was supposed to stick on top of existing one didn't. I tried taking off the white worm infected silver one and it seems I have the old single piece boot badge which is stuck with double sided foam glue. Now I am on the hunt for a badge that I can replace. I don't want to take off (or replace) the entire mechanism.

ryangerry · « **Reply #23 on:** January 11, 2015, 03:46:04 pm »

I bought this one from ebay 111555507066
Just be aware though on the rear are a few little place pieces that stick out I pulled them off and then it literally clipped straight on. It looks pretty secure I'm sure if you wanted to you could use a little bit self adhesive tape or similar to make it 100% secure