All Things MK6 R and GTI > MK6 Members Rides
My Cupra K1 replacement-Golf R mk6
toosmiles:
--- Quote from: OJS3 on January 31, 2016, 11:13:18 am ---Looking good!
Was the intercoolcer a direct fit or was there some customisation needed?
--- End quote ---
direct fit/replacement m8 :happy2:
--- Quote from: Shoduchi on January 31, 2016, 01:23:56 pm ---Lovely engine bay! What else can be said about the care this Golf has? :notworthy:
--- End quote ---
cheers m8 :wink:
--- Quote from: th3_f15t on January 31, 2016, 04:37:50 pm ---Where did you get that rear diffuser from?
--- End quote ---
link of the Golf R forum mike :happy2:
xjay1337:
Diffuser looks great mate. :pomppomp:
toosmiles:
--- Quote from: xjay1337 on February 08, 2016, 05:08:10 pm ---Diffuser looks great mate. :pomppomp:
--- End quote ---
cheers Jay,may need a bit of modding slightly to fit though but shouldnt be a problem
toosmiles:
Finally got round to doing some off the little jobs today
Had these smoked lens mirror in my watch list for months and seeing that mike bought some made my mind up to get some
old mirrors
new installed :smiley:
next job fitting the Bold Sport 3d door warning lights of a member on the mk5gti forum,luckily i enabled these with vcds when i had my battery problems
there just 3 bolts holding this on and some bloody strong clips lol i didnt remove the door card completely,just left the door lock installed,removed the window switch plug and left it sit on my mat as i could get at the door controller module easy enough,popped off the controller cap and added the live to number 18 and ground to number 19,this kit had pins on ready to push straight into the block
popped the cap back on and plugged in the controller module and nowt(damn)anyways i thought id whip the drivers door off and install this to check on the wiring etc,plugged it in and it came on straight away :innocent:
put everything back together as they were identical wiring etc and left it till i got home and checked with the vcds,looked into the drivers door coding and akll was fine so checked the passenger door and it wasnt coded in ready lol,enabled and voila:tongue: ,must admit these are bloody bright at night:cool:
last job as i had some 6d carbon wrap left over from doing my dash trim i thought id whip my door trims off,window down and pull the rubber back and theres 3 hex screws
original is quite scratched but could of been buffed out,if i get bored ill just rip it back off
tbf it blends in well with the carbon mirrors
only a few more jobs to do now,installing my polar fis+,city lights and rear carbon diffuser
cheers
Shoduchi:
More finishing details done. Like it! :congrats:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version