Make a donation

Author Topic: Steering wheel gone heavy after multifunction wheel retrofit  (Read 7500 times)

Offline MAH

  • Always Involved
  • ****
  • Thank You
  • -Given: 1
  • -Receive: 0
  • Posts: 87
    • Email
Re: Steering wheel gone heavy after multifunction wheel retrofit
« Reply #30 on: February 10, 2015, 11:57:51 am »
I dont think so as im doing same things as Ed so no point me to going there hehe

Lol well give me a shout if you have a change of heart  :happy2:. Going to see Ed on the 21st hopefully

Offline SkyJawa

  • Always Involved
  • ****
  • Thank You
  • -Given: 7
  • -Receive: 5
  • Posts: 186
Re: Steering wheel gone heavy after multifunction wheel retrofit
« Reply #31 on: February 12, 2015, 09:06:07 am »
Took me a few attempts at resetting the basic settings and performing the adaption procedure as per Ross Tech, but all resolved in 20 minutes or so.

Just to add, my wheel is also ever so slightly off centre, but it is lined up with the mark on the steering column and indicator cancellation all works fine.  Just a case of getting the alignment done to get the wheel straight again I reckon.
« Last Edit: February 12, 2015, 10:26:45 am by SkyJawa »

Offline MAH

  • Always Involved
  • ****
  • Thank You
  • -Given: 1
  • -Receive: 0
  • Posts: 87
    • Email
Re: Steering wheel gone heavy after multifunction wheel retrofit
« Reply #32 on: February 12, 2015, 11:16:11 am »
Thanks guys, got it sorted. Took the steering wheel and noticed that the wheel had not been lined up straight with the slip ring. As soon as i sorted that, the steering went light and error lights turned off.

For anyone carrying out this mod, please make sure you line both the wheel and slip ring straight

Thanks

Abaid

Offline Andy

  • Admin
  • Just look at my post count
  • *
  • Thank You
  • -Given: 39
  • -Receive: 443
  • Posts: 10931
    • Email
Re: Steering wheel gone heavy after multifunction wheel retrofit
« Reply #33 on: February 15, 2015, 03:06:06 pm »
Good to see you got it sorted