I'm really struggling with this mod and can't get it to work :(
There are loads of guides, been scouring the net for ages but every one leaves guess work :(
Plug 'A' black
remove pin 16 and remove pin 20
put wire 16 in hole 20 and leave wire 20 loose.
Plug 'B'
pin 6 to pin 7
I already have a wire in pin 7
do I remove wire 7 and leave it out?
Plug 'C'
pin 7 to pin 10
I already have a wire in pin 10
do I remove wire 10 and leave that out?
Plug 'C'
pin 8 to pin 9
I already have a wire in pin 9
do I remove wire 9 and leave that out?
Sorry to bring this up again but if the above wires are to be 'joined'
I'd like to know. I don't wish to just join wires and hope for no smoke :(
Also I'll need to fit Aie Quality Sensor later
Thats confusing too.
Some guides state connector 'C' but I think it means Connector 'A'
as it mentions the earlier 16 to 20 wire swap earlier
on connector 'A'Pin 1 to pin 20 - well that now has wire 16 in.
(or does it mean joined to the 'now floating wire 20' and not actually in the socket at all)
Pin 2 to pin 19
That also already has a wire in pin 19 are these joined or what?
Pin 3 to pin 4 I think that is empty.
@Eddie-NL If I buy a conversion loom off you, I hear you make them up.
Is it just a plug & play loom with all three plugs and sockets to simply pliug inline?
I'm pulling my hair out here....LoL