Make a donation

Author Topic: Front console bushes  (Read 6853 times)

Offline r5gtt

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 342
  • -Receive: 334
  • Posts: 5586
Re: Front console bushes
« Reply #15 on: April 30, 2016, 04:54:41 pm »
Here's a wicked deal on fleebay

331842230469

Offline Mark_DF05

  • Always Involved
  • ****
  • Thank You
  • -Given: 23
  • -Receive: 9
  • Posts: 268
Re: Front console bushes
« Reply #16 on: April 30, 2016, 11:21:06 pm »
Ace, thanks!

Are they the correct ones then, it says rear? Sorry my suspension knowledge doesn't extend much further than springs and dampers.

I assume I'll need the garage to press them into the brackets?


Offline r5gtt

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 342
  • -Receive: 334
  • Posts: 5586
Re: Front console bushes
« Reply #17 on: April 30, 2016, 11:24:47 pm »
@Mark_DF05 yes they are the correct ones.
They are front wishbone rear bushes meaning the fit at the rear of the wishbones and a bargain for the lot imho.
I'd advise you get a garage to press them out and in unless you have access to a vice and are willing to gemive it a go at pressing them out and back in?.

Offline Mark_DF05

  • Always Involved
  • ****
  • Thank You
  • -Given: 23
  • -Receive: 9
  • Posts: 268
Re: Front console bushes
« Reply #18 on: April 30, 2016, 11:30:58 pm »
Ah right, makes sense now!

Got a vice so could have a go buy failing that I'll just get the garage to do it with the right tools. Thanks for the help mate.

Offline r5gtt

  • Just look at my post count
  • ******
  • Thank You
  • -Given: 342
  • -Receive: 334
  • Posts: 5586
Re: Front console bushes
« Reply #19 on: April 30, 2016, 11:46:14 pm »
You'll also need some kind of spacer solid socket similar width to push the out and in with.

Good luck and no worries  :smiley:

Offline Mark_DF05

  • Always Involved
  • ****
  • Thank You
  • -Given: 23
  • -Receive: 9
  • Posts: 268
Re: Front console bushes
« Reply #20 on: May 01, 2016, 11:06:58 am »
Back again!

After searching the forum I don't think those SuperPro ones on eBay are quite the same as they ones they sell with the bracket so I'm thinking of just going with S3 ones as I don't really have £150 to spend on them.

Can anyone confirm that these part numbers are correct and the bracket fits as a direct replacement?

-1K0199231N
-1K0199232N