Bit of weight over the back axle wouldn't hurt in some cases and also has a benefit in that the weight is lower in the car and therefore would counter the increased weight of a big turbo and pipework that would raise the c of g.
Lower vertical c of g = less weight transfer so to get the same weight transfer you can brake later and harder without overwhelming the contact patch
You'll be needing brakes that will probably give an increase in weight over the stock S3/Cupra kit to cope with the additional capability in terms of corner arrival speed and heat generation..
500BHP is achievable but will hurt like a bitch, better to aim for 400-450 and have the reliability/traction/driveability, there are some 50 page build threads over on SCN about this and its months of a job with lots of off road time and a 5 figure budget and not always with good results.
A 4WD cupra will be a unique car and a big player on the show scene if thats where you want to go with it
450hp would be nice, 400 wouldnt satisfy me though.
Would love to get the car up to show spec, mags etc.
4WD = weight full stop...unless u do some stripping!
Carrera S with charger? why?
Might aswell buy a GT2 or Turbo!
Price. Carrera S about 35k, another 7k for the charger kit. Actually the charger kit will bump the normal 911 carrera up to the same power as a charged 911.
Obviously I have a dilema? What car is good round corners, and is quicker than a stage 2 plus k04 without costing 80-90k?
Is the floor pan on the gti the same as on the R - this could be a very interesting project, could be tempted by this !
Regards,
Gareth
The canadians have done it, they cut the boot floor and had to make it shallower, and re-run the the exhaust system. Tbh it doesnt look all that complicated, but then again, is the wheelbase for the leon and the golf 100% the same?