All Things Mk5 > Revo Zone

K04 runner flap delete software

(1/4) > >>

Burbs22:
Just want to know if/when you will have this available on revo software.
I really want to get my inlet mani off to do a carbon clean and want to fit rfd at the same time to kill 2 birds with one stone but revo don't support it. I know I can fit it but it will run rough when cold and have eml on but I don't want that.
Are you going to release rfd software any time soon as a lot of people won't do rfd because you don't support it and it's easy enough to do when doing a carbon clean.

mk5-beast-91:
there working on one atm. not sure when it will be available tho.

Dan_FR:
They've been working on it for ages, apparently, although whenever i've asked them, they won't commit to it. Too much money to be made developing new software for newer cars than revisiting old software.

The car will run fine with the RFD. The only time it runs rough from cold is the first few times until the car adapts, which it will. Also never had an EML, either with or without the motor plugged in

Scotty600:
Will it be ok then to do a runner flap delete or is it gunna run rough

rich83:
Just spoken to Paul at REVO and they are working on it amongst other things.

Navigation

[0] Message Index

[#] Next page