General > Detailing
Orbital Polisher Newbie
dansmith180:
Just buff off with a nice soft microfibre like normal mate, most machine sealants want to sit for 20mins or so meaning you can normally apply to half the car then buff off and repeat
dazza:
--- Quote from: dansmith180 on November 12, 2015, 11:55:09 am ---Just buff off with a nice soft microfibre like normal mate, most machine sealants want to sit for 20mins or so meaning you can normally apply to half the car then buff off and repeat
--- End quote ---
Thanks mate looking forward to getting stuck into this. Hopefully i will be a bit happier with the results.
dansmith180:
:happy2:
dazza:
Made a start on the paint today. Usually i would have left it until spring but some **** keyed the bonnet.
Two bucket wash followed with the clay bar then wipe down with some red mist. I struggle buffing anything off could it be i use to much product or the microfiber cloths are too soft?
Done a couple of sections of the bonnet with the flex vrgs, Rupes UHS polish and a yellow lake country pad bye bye swirls. :fighting:
The machine is easier on the arms than the das6 i can feel the panel getting warm.
Should i do a complete pass on the bonnet then come back to the scratch?
dazza:
Its going to take some time to get the scratch out. Does the Rupes UHS polish have more cut than the Chemical Guys V32?
How hot can i let the panel get?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version