Engine light came on earlier, did a scan with Vagocom which revealed this:
-------------------------------------------------------------------------------
Address 01: Engine Labels: 06F-907-115-AXX.lbl
Part No SW: 1K0 907 115 J HW: 8P0 907 115 B
Component: 2.0l R4/4V TFSI 0030
Revision: --H14--- Serial number: VWZ7Z0F8040446
Coding: 0403000318070060
Shop #: WSC 00200 210 89989
VCID: 2D577FEFB493EC7600B-8078
3 Faults Found:
000256 - Mass Air Flow Sensor (G70)
P0100 - 004 - Supply Voltage - Intermittent
Freeze Frame:
Fault Status: 00100100
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 154200 km
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Load: 0.0 %
Speed: 0.0 km/h
Temperature: 50.0°C
Temperature: 38.0°C
Absolute Pres.: 1030.0 mbar
Voltage: 11.811 V
012599 - Intake Manifold Runner Control
P3137 - 001 - Basic Setting not Completed - Intermittent
Freeze Frame:
Fault Status: 00100001
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 154913 km
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Load: 0.0 %
Speed: 0.0 km/h
Temperature: 54.0°C
Temperature: 51.0°C
Absolute Pres.: 1010.0 mbar
Voltage: 12.065 V
001602 - Sensor Reference Voltage A: Circuit
P0642 - 002 - Low - Intermittent - MIL ON
Freeze Frame:
Fault Status: 10100010
Fault Priority: 0
Fault Frequency: 1
Reset counter: 255
Mileage: 154913 km
Time Indication: 0
Freeze Frame:
RPM: 0 /min
Load: 0.0 %
Speed: 0.0 km/h
Temperature: 54.0°C
Temperature: 51.0°C
Absolute Pres.: 1010.0 mbar
Voltage: 12.192 V
Readiness: 0000 0000
I reset the codes and also performed a basic setting which i found was recommended after an online search. I also tried an output test and the runner flap motor was functioning fine. Ive had this code before a while ago.
Is this a major problem? How can it be fixed for good?
Cheers!
