MK5 Golf GTI
All Things Mk5 => Mk5 General Area => Topic started by: Spooky1 on September 18, 2012, 03:00:49 pm
-
Hello,
I have only just realised that my glove box handle is almost broken.
The chrome locking latch bit doesnt like opening because it looks like some oaf (me) pulled on it while it was locked.
I have spoken to the dealer about a possible fix and they replied "its a common fault, the pins used to retain the locks were weak and sometimes break."
The repair kit is a brand new glove box lid with better pins, but a whopping £225 supply and fit.
Does anyone know of a cheaper work around?
ta.
-
Have you checked eBay as some appear on there
-
there is a screw on the inside part of the lid, take that out and the handle can be removed
you can then buy a replacement one for about £8
-
I might have to do this as they put a poxy black one in the Pirelli and I want a silver one!!!
-
I might have to do this as they put a poxy black one in the Pirelli and I want a silver one!!!
You can have
Chrome or brushed Ali (both plastic with foil covering)
-
I might have to do this as they put a poxy black one in the Pirelli and I want a silver one!!!
You can have
Chrome or brushed Ali (both plastic with foil covering)
Brushed ali I think to match the rest of the interior trim. :happy2:
-
Brushed Aluminium
Part number is: 1K2 857 147E 3Q7 (£9.30)
-
there is a screw on the inside part of the lid, take that out and the handle can be removed
you can then buy a replacement one for about £8
Thanks eddie, ill give that a go. :happy2:
-
there is a screw on the inside part of the lid, take that out and the handle can be removed
you can then buy a replacement one for about £8
Being a complete numpty at these things, I've just tried to remove the old handle but no joy.....what type of screw is holding it in place? Can't seem to get a screw driver small enough into the gap between the lid and the centre console? :ashamed:
-
I think it's a T20 torx
-
just be careful the screw doesn't drop inside or you have to take the whole glovebox out to retrieve it
-
Cheers guys, tried a T20 torx driver but it's too long to get in between the centre console and the glovebox. My ratchet set bit is to big to go in the hole in the glovebox lid! What should I be using? :ashamed:
-
Hello again,
Well I had a go at removing the torx screw, but when I opened the handle to gain access to the screw the handle came clean off in my hand. It was only hanging on by a thread!
So now I guess I'm going to struggle to get the glove box itself open to remove the lid to get the new handle and mechanism in.
Bugger.
-
I have a dark grey glovebox in the shed, PM me if interested. I'm overdue a clearout!
-
Well Skard sold me his glove box and it is perfect, I have a working glovebox again!
Cheers pal!
-
:happy2: