MK5 Golf GTI
All Things Mk5 => Mk5 General Area => Topic started by: N44LED on May 20, 2014, 11:53:46 pm
-
Hi guys
Just wondering of there is any guides on how to remove the side trims really. As iam trying to install the dab aerial wire.
Thanks
Aled
Sent from my iPhone using Tapatalk
-
I know the b pillar trims you have to remove the airbag badge and there is a torx screw behind it then it should just pop of.
I hope this is of some help to you.
-
The C pillar trim needs pulling out at the top (bolt under airbag logo), then the roof lining will drop enough to pass the wire through. I took the outer fakra plug bit off to make the cable end smaller to pass through.
-
What these guys have said but there are few workshop manuals on here if you search about.
The manuals will show you what directions to pull them in to minimize damage.
:grin:
-
If u do it then be careful when refitting as I lost the screw behind all the other internal panels! Not sure what size it is to replace either!
-
I removed the panel above the pedals (2 torx screws) the fuse cover and the thin long panel next to this.
The cable can be tucked under most of the side trim where it meets the carpet without removing.
C pillar as said remove airbag badge carefully and reuse it This will allow you to tuck the cable behind
Plastic trim at rear of headlining can be pulled off No screws but be careful not to snap
You will need small hands if you are replacing the aerial :happy2:
Just fitted the kinetic 6003 aerial replacing the window effort
-
Read step 4 of this guide but the whole guide is good reading!
http://www.mk5golfgti.co.uk/forum/index.php/topic,10027.0.html