Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Stereo fitting  (Read 901 times)

Offline GTIdanman

  • Taking part
  • ***
  • Thank You
  • -Given: 15
  • -Receive: 0
  • Posts: 38
    • Email
Stereo fitting
« on: April 11, 2015, 10:07:20 am »
Hi all. Anybody know any good how to guides on how to fit after market stereo. I have seen a couple of videos on YouTube but they don't explane it very well.
Thanks Dan.
Logged

Offline andy7ven

  • Always Involved
  • ****
  • Thank You
  • -Given: 9
  • -Receive: 30
  • Posts: 200
Re: Stereo fitting
« Reply #1 on: April 11, 2015, 03:34:44 pm »
Can't get no simpler than this one mate...

https://www.youtube.com/watch?v=ko5-G9YwTpE
« Last Edit: April 11, 2015, 03:36:23 pm by andy7ven »
Logged

Offline VW_Jace

  • Always Involved
  • ****
  • Thank You
  • -Given: 2
  • -Receive: 0
  • Posts: 54
    • Email
Re: Stereo fitting
« Reply #2 on: April 11, 2015, 04:20:48 pm »
theres a whole section in the how to guides area of the forum...
Logged

Offline ruhaleali

  • Always Involved
  • ****
  • Thank You
  • -Given: 9
  • -Receive: 3
  • Posts: 228
Re: Stereo fitting
« Reply #3 on: April 15, 2015, 05:16:47 pm »
Quote from: GTIdanman on April 11, 2015, 10:07:20 am
Hi all. Anybody know any good how to guides on how to fit after market stereo. I have seen a couple of videos on YouTube but they don't explane it very well.
Thanks Dan.

Might sound funny but, if you know how to remove the entire centre console then fitting the stereo is s easy depending on if its double din or single din and if the system has extras such as a microphone or aux these have to be directed to your required location but simply plug into the back and play.
Logged

Offline Blackgtiman

  • Always Involved
  • ****
  • Thank You
  • -Given: 2
  • -Receive: 2
  • Posts: 85
Re: Stereo fitting
« Reply #4 on: April 15, 2015, 08:41:19 pm »
Logged

Offline PhilNUK

  • Always Involved
  • ****
  • Thank You
  • -Given: 32
  • -Receive: 6
  • Posts: 267
    • Email
Re: Stereo fitting
« Reply #5 on: April 15, 2015, 09:43:29 pm »
Hardest bit for me was removing the fascia to access the screws...  Trying to be careful and not snapping the tabs on the back...  I switched my old one out for the rns510 and it was all straightforward..  Just make sure you have all the bits you need before you start
Logged
Pages: [1]   Go Up
« previous next »