Author Topic: Will much arch work be needed? (Read 1183 times)

v6yna · « **on:** May 21, 2013, 06:28:35 pm »

Ive had the screw mod done on the front arches, and am getting them rolled this week, but want to know if they will have to be pulled out if i want to run 19x9 et45? anyone know? Cheers

valle · « **Reply #1 on:** May 22, 2013, 02:33:18 pm »

depends how low would u go ...

v6yna · « **Reply #2 on:** May 22, 2013, 05:10:40 pm »

its on air, so doesnt matter too much running height, but when dropped i would like them to tuck...

xjay1337 · « **Reply #3 on:** May 22, 2013, 05:13:12 pm »

I am pretty sure a 19x9 et 46 hits the strut.
I know Bentley wheels are 19x9 et41 which is about the most you can go on a front. At et45 you might need a 5mm spacer.

RedED30 · « **Reply #4 on:** May 26, 2013, 04:29:57 pm »

Quote from: xjay1337 on May 22, 2013, 05:13:12 pm

I am pretty sure a 19x9 et 46 hits the strut.
I know Bentley wheels are 19x9 et41 which is about the most you can go on a front. At et45 you might need a 5mm spacer.

correct, 9's on the rear will leave you a little room for some camber, not sure on fronts - assuming your running a 35 profile tyre?

Author Topic: Will much arch work be needed? (Read 1183 times)

v6yna

Will much arch work be needed?

valle

Re: Will much arch work be needed?

v6yna

Re: Will much arch work be needed?

xjay1337

Re: Will much arch work be needed?

RedED30

Re: Will much arch work be needed?