Guys, sorry to ask this again, but I don't think I got a response to my last post.
Tomorrow, the Golf is going and I'm picking up my new Scirocco. One of the first things I'll be doing is removing the standard RCD-510 and replacing it with my RNS-510 Nav unit. I've ordered the car with the factory bluetooth unit, but as mentioned with the standard RCD-510 (albeit Dynaudio). So i'll have a microphone already installed in the overhead console, but it's my understanding as there is no Nav in the car from the factory, that it ONLY goes to the bluetooth unit under the seat (like my crap sketch below) completely bypassing the back of the RNS.
It's my understanding (although please correct me if I am wrong), that to get the voice control to work (apart from a bit of VCDS coding), I need to feed the mic into the back of the RNS, then out to the bluetooth unit ? (like the crap 2nd picture below).
My question is, will the factory installed microphone cable have the takes offs (connectors) already there to plug straight into the back of the RNS (say near the A-Pillar), or will it ONLY go to the bluetooth unit with no spurs. In that case, is it best to try and modify the existing cable, or replace it completely with a Kufatec "voice control" cable assembly.
Finally, as my unit is currently running Version 1300 firware (which as I understand it doesn't support voice control), I obviously need to update it. Would it be the 2760 firmware that vRS Carl put a link to in his sticky above ?
Cheers in advance chaps.
Andrew