Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: Colour codeing splitter  (Read 841 times)

Offline Gazzgti

  • Always Involved
  • ****
  • Thank You
  • -Given: 1
  • -Receive: 3
  • Posts: 78
    • Email
Colour codeing splitter
« on: February 27, 2012, 07:39:00 pm »
Thinking of having a go at this myself. Anyone got any tips?
Logged

Offline Luka

  • Always Involved
  • ****
  • Thank You
  • -Given: 6
  • -Receive: 32
  • Posts: 388
Re: Colour codeing splitter
« Reply #1 on: February 27, 2012, 07:50:50 pm »
Ideally remove the splitter from the vehicle. Prep is 90% of all paint work and the key to a good finish. Ensure this is done correctly and you should be ok. Mask up all areas carefully. Time spent in these areas will be well worth it.
Logged
Sold - 2006 Tornado Red GTI 3dr

Offline Gazzgti

  • Always Involved
  • ****
  • Thank You
  • -Given: 1
  • -Receive: 3
  • Posts: 78
    • Email
Re: Colour codeing splitter
« Reply #2 on: February 27, 2012, 07:58:42 pm »
Cheers any idea which prima I should be looking at.
Logged

Offline Luka

  • Always Involved
  • ****
  • Thank You
  • -Given: 6
  • -Receive: 32
  • Posts: 388
Re: Colour codeing splitter
« Reply #3 on: February 27, 2012, 10:09:40 pm »
High build would be best. Few good coats with sanding in between. Standard primer after with wet sand. Paint, then clear. I'm no professional but that's the general route I've taken in the past, based on what I've learnt. Feel free to correct me if I'm wrong folks!  :grin:
Logged
Sold - 2006 Tornado Red GTI 3dr
Pages: [1]   Go Up
« previous next »