Make a donation
« previous next »
Pages: [1]   Go Down

Author Topic: just fitted my wonky milltek..  (Read 932 times)

Offline karl210

  • Always Involved
  • ****
  • Thank You
  • -Given: 2
  • -Receive: 6
  • Posts: 258
    • Email
just fitted my wonky milltek..
« on: February 19, 2013, 10:48:55 am »
Fitted my Milltek catback last night and it seems to hang a bit low and a bit wonky, any ideas? ive tried the bend the right tailpipe up but its pretty strong, is anybody elses like this?
Logged

PSW

  • Guest
Re: just fitted my wonky milltek..
« Reply #1 on: February 19, 2013, 12:01:49 pm »
^^^
sell it and buy a BCS ...... :innocent:
Logged

Offline jimojameso

  • Always Involved
  • ****
  • Thank You
  • -Given: 0
  • -Receive: 9
  • Posts: 271
Re: just fitted my wonky milltek..
« Reply #2 on: February 19, 2013, 12:56:34 pm »
I can't see your picture as im at work but my milltek used to it perfectly!!  :confused:
Logged
2010 Audi TT RS - Sepang Blue - 420BHP, 600NM

Offline DFish

  • Always Involved
  • ****
  • Thank You
  • -Given: 6
  • -Receive: 14
  • Posts: 368
Re: just fitted my wonky milltek..
« Reply #3 on: February 19, 2013, 01:04:20 pm »
Plastic hammer would fix that.

Fish
Logged

Offline andybon

  • Won't Shut up.
  • *****
  • Thank You
  • -Given: 11
  • -Receive: 8
  • Posts: 540
Re: just fitted my wonky milltek..
« Reply #4 on: February 19, 2013, 05:06:14 pm »
 Slacken the joint on the backbox and twist the backbox until it sits right in the hole, had similar problems when I've fitted them in the past.
Logged
How hard can it be?

Offline karl210

  • Always Involved
  • ****
  • Thank You
  • -Given: 2
  • -Receive: 6
  • Posts: 258
    • Email
Re: just fitted my wonky milltek..
« Reply #5 on: February 19, 2013, 10:12:11 pm »
cool il give it a go cheers. I put a block of wood between the left pipe and the heatshield then i put a long bar in the right one and tried to jig it up a bit but there bloody strong!
Logged
Pages: [1]   Go Up
« previous next »