How Stock is the REVO "Stock" setting?

[rich83]

Long story short....

Had to put some ASDA fuel in tonight, so I plugged in the SPS on position 1 "stock"

Car still seemed to perform well.

Just before I got home I used Dynolicious to log a 0-60 and it was 6.1 seconds and came out at 262bhp with the rough estimation.

My last 0-60 run was 5.39 seconds with B9 T4 F8 (I think)

So 6.1 seconds doesnt seem like total stock to me.....


Rich

[rich83]

So no ones put their car back to stock settings?

[E30Dom]

Obviously no one lets their wife/girlfriend drive their cars... 

[dokez]

Dont see the point tbh after paying all that money for a map. Even putting in crap fuel if i HAVE too i just drive off boost untill Vpower is about.

Only time it was back to standard settings when the battery had been disconnected and i took it for a drive and yes was slowwwww compare to 8/5/9

[rich83]

It was more of a test to see what it ran like on the stock settings.... first time ive done it.

[dokez]

It was more of a test to see what it ran like on the stock settings.... first time ive done it.

Has the sps been programmed to store the stock settings on setting 1 ? IIRC it should be 0/0/1(Boost) stock ??

Plug her in again + Laptop and open the SPS program up and see what it reads on dial 1.

[rich83]

It was more of a test to see what it ran like on the stock settings.... first time ive done it.

Has the sps been programmed to store the stock settings on setting 1 ? IIRC it should be 0/0/1(Boost) stock ??

Plug her in again + Laptop and open the SPS program up and see what it reads on dial 1.

IM sure that the setting 1 cannot be altered by the user

[john_o]

its considered 'stock like' not stock per se
mine certainly pulled more boost than stock on that setting, ergo faster.
so yes,I concur with your experience 

[stealthwolf]

IM sure that the setting 1 cannot be altered by the user

No but you should be able to read the setting even though you can't write to it.

FWIW I had the SPS on B1T1F9 and it still did about 260-270 on JKM rollers. When changed to B7T5F9, it went to what it should have been.

[rich83]

My "stock" settings at B6 T3 F7

So thats why it doesnt feel slow... but feels flat!

[GTI-Pirelli]

Obviously no one lets their wife/girlfriend drive their cars... 

I let my fiancee drive mine. I think she looks after it better than me! She seems to think I would actually kill her if she broke it.

I only ever turn it to "Stock" to "recalibrate my right foot" then when I am happy it is painfully slow (Not that it was much of a slouch) it goes back on!
 

I don't even both to turn it to "stock" for a service any more, because I asked about a couple of intermittent faults once at VW and they said; "It's probably because it has been remapped". So it would appear they can tell the difference between "VW Stock" & "Revo Stock".

[heavyd]

I think when I had mine set to stock, it ran circa 250bhp.
fuel still requested 130bar from the hpfp, so stock isnt fully stock!