What did you and your MKV do today?

[4ndy]

installed drivers seatbelt  Old one was getting Very worn,frayed. Easy straight forward as long as you have small hands  

[GTI8v]

Several hours with a DA polisher ended up looking like this...




Knackered now, but pleased with the results

[r5gtt]

Several hours with a DA polisher ended up looking like this...




Knackered now, but pleased with the results

it is a tiering job to do.

Looks sweet and the best colour too 

[GTI8v]

Thanks 
Enjoyed putting the wax on though, Poor Boy's World, Natty's Paste smells lovely 

[r5gtt]

Thanks 
Enjoyed putting the wax on though, Poor Boy's World, Natty's Paste smells lovely 

Anything is better than nothing imho   

[leericho]

Give it a good rattling up and down a quiet straight near me, 3rd gear beings big grins

[ROH ECHT]

Had what seemed like a pretty bad leak from the driver's side intercooler pipe, on both ends of the pipe (more so on the radiator side).


Couple of o-rings from VW later and... this has been after 3 days and no boot leaks that I can tell of and no oil showing!

You removed the factory catch-can by adding those new o-rings 

[ROH ECHT]

Replaced the front bumper today...had the new one sitting in a bedroom since last fall from raccoon damage...waited for one more winter to end and the snow gravel to be mostly swept up. Wasn't a bad job to do...less than 4 hours including my old man breaks 

[r5gtt]

Had what seemed like a pretty bad leak from the driver's side intercooler pipe, on both ends of the pipe (more so on the radiator side).


Couple of o-rings from VW later and... this has been after 3 days and no boot leaks that I can tell of and no oil showing!

You removed the factory catch-can by adding those new o-rings 

well said 

[4ndy]

These with textar pads. BBS CH et50 don't fit unless you want to start removing metal with a grinder,dremel etc  Have 10mm spacers and new m14 studs to fit until I find nice wheels  Was thinking TD1.2,1.3. BBS CS5 from http://www.revolution247.com/catalogue/shop-by-category-alloy-wheels-bbs/bbs---cs-5-alloy-wheel-satin-anthracite-with-diamond-cut-face  just need to paint them black

[Rossimac]

Had what seemed like a pretty bad leak from the driver's side intercooler pipe, on both ends of the pipe (more so on the radiator side).


Couple of o-rings from VW later and... this has been after 3 days and no boot leaks that I can tell of and no oil showing!

You removed the factory catch-can by adding those new o-rings 

Haha, I sensible chuckled! Guess what's showing after 3 days of boosting..... Oil!

Fml

[jay26r]

painted the grill stripe red (some tool painted it baby blue ) and painted the brakes

[GTI8v]

painted the grill stripe red (some tool painted it baby blue ) and painted the brakes

Wouldn't have parked so close to the drain... I'd end up losing a locking wheel bolt or something equally as important 

[flashp]

painted the grill stripe red (some tool painted it baby blue ) and painted the brakes

Wouldn't have parked so close to the drain... I'd end up losing a locking wheel bolt or something equally as important 

That would have been my luck as well!   

[r5gtt]

painted the grill stripe red (some tool painted it baby blue ) and painted the brakes

Wouldn't have parked so close to the drain... I'd end up losing a locking wheel bolt or something equally as important 

That would have been my luck as well!   

When I was fitting my dv + on I had no choice and the spline bit fell into the drain but luckily I had some chewing gum on me and a long driver to pull it back out with otherwise that fecking drain was coming out