What did you and your MKV do today?

[Jonny]

Well it was pretty sunny so I gave the car a thorough cleaning... Wheels off, arches cleaned, it really needed it

[Horatio]

Just picked it up from DMR! 

that. is. a. nice. finish 

The trick now is, to wash it without washing it

[paulw123]

Did oil change on me 2008 gt tdi sport. Went to replace vw filter with new vw filter from same dealer, and they were different  New one had black plastic top & bottom and was about 4mm longer. Was'nt sure the cap would tighten down, but it did just fine, so seems ok....
Also it takes me ages trying to get the large plastic undertray back onto the front splitter, is there a trick to this?

[marko]

i cut a hole in mine round the sump plug so i can drain and not remove the tray..

[ReeceH13]

Well, at the weekend...

Door card off, replaced inside door grab handle, and then the drivers side, slightly easier! Makes a big difference. Looking fresh...

[jonnym]

FINALLY got the wheel off!!
Had to weld a nut onto the lug but got it off within seconds!

[Banham]

Currently at R-tech getting a custom map 

[Saintsteve]

Currently at R-tech getting a custom map 

I'm up Thursday 

[teesee]

At awesome gti for cruise control  (driving to the cairngorms this week) and boot pop activation :)

[red6688]

Fitted 18 monza back to standard but garage increased coilover ride height but still low , not sure whether to increase more or stay low
Good bye  alphards Sold to member

Starting to regret selling a little as looking good when cleaning :(

[Matto]

Picked the Milltek back box up from the powder coaters.

[DFish]

Deep cleaned and sealed the summer wheels ready to be put back on in circa 24 hours. Finally the weather has improved enough to put them back on.

Fish

[Veee-dubber]

Picked the Milltek back box up from the powder coaters.

Out of interest why have you had it powdercoated?

[jamiep91]

Took it to see what it's being replaced with :-)  BMW m3 e46

Sent from my GT-I9300 using Tapatalk 2

[Matto]

Picked the Milltek back box up from the powder coaters.

Out of interest why have you had it powdercoated?

As with most of the Milltek backboxes (except the newer ones), they have the tendency to hang below the bumper. I'm not sure whether this one will or won't so had it powder coated just in case so it won't stand out like a sore thumb