What did you and your MKV do today?

[z00bz]

Been busy with gettin a few bits done to her and managed to have it all completed today...

So with a Oil & Filter change, It was time to get these bad boys replaced


New follower vs Old Follower


State of my Old DV


And finally.....



Car seems to be driving spot on as always

[K9]

Did a dsg vcds reset after had the car remapped stg1+ 

[USBulldog]

Fitted my Depo headlights with HID kit.

[RetroRaz]

Ran shutter wires to my cecm for my xenons and coded them as US style :D

[SeyiiOluwa]

Ran shutter wires to my cecm for my xenons and coded them as US style :D

Let's see

[RetroRaz]

Ran shutter wires to my cecm for my xenons and coded them as US style :D

Let's see

Going to make a video on how to do it and how they look compared to UK style.  Will post build thread in a few days

[Rossimac]

Going to make a video on how to do it and how they look compared to UK style.  Will post build thread in a few days

Any chance you could show the CECM position? I've got my cables in the cabin but not sure where to go next. MY07 btw 

[RetroRaz]

Going to make a video on how to do it and how they look compared to UK style.  Will post build thread in a few days

Any chance you could show the CECM position? I've got my cables in the cabin but not sure where to go next. MY07 btw 

The cecm is above the gas pedal.  Take the footwell cover off and look above.  There will be a load of wires going into connectors.

[PT82]

Well thinking it would never happen to me the Golf has decided to treat me on its 40,000 mile birthday to a rusty sill. I noticed when washing it tonight. I have emailed VW Shrewsbury and am awaiting their reply. Fingers crossed it's good news!

[numec]

Small interior update with GTI stickers [emoji4]

[JimmyC92]

The missus is re stitching my shift gator with red stitch  Hope she does a good job...else she'll be sleeping on the sofa...

[prp74]

Lowered the car with some eibach springs bought from a fellow member.

[HandyAndy]

I fitted new rear springs and shocks on my GTs. When it went in for the service tother week, it was marked as an advisory as the n/s rear was leaking.

I called into Euro car parts in town and got the bits. Along with an air filter as this wasn't changed during the service. Only cost £150 give or take a few pence, it only took about 4 hours on the drive with my new little trolley jack from that there halfords. Not a bad little jack for £25.

I'll give it a week and check the bolts again for tightness, as I didn't have my torque wrench to hand.

[Neil 54]

Went to see Alex Had 42 DD shifter bushes, AKS shifter bracket bushes and a new lateral bracket fitted nicely improved shifts
Thanks Alex

[patpong_pete]

Small interior update with GTI stickers [emoji4]

HI where did you get your GTI Stickers from ?

thanks for the reply